These are two "model" codes and are offered as suggested guidelines for local code authorities to follow at their discretion. Figure 1: Handrails mounted on the top of stair barrier. The way this is measured is to begin at the leading edge of the stair nosing and run an imaginary vertical line upward until it reaches the top of the railing. The theory is that a person may become injured by falling off of an 18 inch-high deck, for example, but nowhere near as severely as if that person fell 8 feet down. The same measurement applies to all of the stair nosings, thus resulting in a railing that is parallel to the stairs. As with exterior deckingno guards or rails are needed if the surface is close enough to the ground: 30 inches or less. Print Print this page recommended This will print only the current page of this guidance document. One word on terminology: Stair railing and stair guards, though they may sound like the same thing, are different. Read More. Guards are the rails that protect users from falling off of high areas, such as landings.
Barriers and handrails Building Performance
Building Code Congress International (SBCCI) – the Southern Building Code ( SBC); and. Handrail Height: Placed between 34" and 38". Question: Under the construction standards, can a inch-high top rail for a stairway also serve as a handrail, or must a handrail also be.
Acceptable Solution B2/AS1 Table 1 specifies the durability requirements of nominated building elements. Table 1 states that safety barrier.
Guards are the rails that protect users from falling off of high areas, such as landings. However, because communities often adopt and adapt the model code, it is necessary to check with your local building code authority usually the city building department for code that pertains to your community.
Not only are they logical, but they carefully follow established building code requirements.
As with exterior deckingno guards or rails are needed if the surface is close enough to the ground: 30 inches or less. Handrail height on the stairs should be no less than 34 inches and no greater than 38 inches. Measure this distance from the side of the handrail closest to the wall and extend the line to the wall.
Unfortunately fatal mountain climbing falls occur from time to time, but many of them are not vertical falls.
A summary of the handrail requirements under AS Posted by The cross-section of the handrail must be circular or elliptical, with a For easy handrail compliance in a Class 9b building used as a primary school.
If you need a response, contact us.
But other projects, especially those that are related to safety, such as electrical and plumbing, are strictly by-the-book.
Handrail height on the stairs should be no less than 34 inches and no greater than 38 inches. A court decision some time ago Judge MA Frater, District Court Gisborne, 29 May dealt with a situation where there was a cliff with a platform at the top, mm above a small retaining wall and set back about one metre from it.
If there was no barrier on the deck, the determination concluded the deck needed to be mm from the face of the wall to protect people from falling off the deck and tumbling down the wall. As with exterior deckingno guards or rails are needed if the surface is close enough to the ground: 30 inches or less.