Why would they have 2 different system and support for them? I think I see a 4PL in my future. Thread Tools. This again increases the possibility of a conflict between two S-FHSS systems operating in the same vicinity. I use a 3PJS thats an old radio and I can still get support if need be. Can some one please explain the difference in these type of Futaba receivers.
Can some one please explain the difference in these type of Futaba receivers. I was interested in the new Futaba 4PL and see it's a FHSS.
I am not sure if S-FHSS is the same, or if it is a completely different protocol. This little aeroplane i have flown only a few times because i have to.
Futaba Radios Direct support forum - S-fhss and fhss - What's the difference between S-FHSS and FHSS?.
BB code is On. A bit transmitter ID. Conclusion Better protocol design would give longer range and better resistance to interference while retaining the same frame rate and using the same hardware. If it is 27 the maximum value then the channel number is effectively decremented by 3.
Add a Poll to this Thread.
Duster, You have summed it up for me. Only 28 hopping codes are available, even though there are something like 29!
Spr buildtech complaints definition
|Email required Address never made public. If they did discontinue one, they would prob come up with an option for rcvrs so those that were sold would still be useable.
Only 28 hopping codes are available, even though there are something like 29! After all packets have been transmitted, the transmitter changes frequency.
Video: S-fhss vs fhss Futaba T3PV Radio Review, T-FHSS, S-FHSS
I've never seen them totally abandon something like that. They make them incompatible with each other so the 4PK guys can't use the cheaper rcvrs that go with the PL.
Futaba SFHSS Protocol Overview RF Eng FPV
Each hop consists of one or more packets.
Why would they have 2 different system and support for them? Data Rate By eliminating redundancy, including the dead time between packets, it would be possible to reduce the user data rate without affecting control latency.
Is there a latency difference between the different types? The 2.
BB code is On. Note that the factor of 2 in the numerator is because the two hop sequences will not be time aligned, which doubles possibility of interference as only a small overlap between frames on the same frequency would be sufficient to cause a conflict, as no forward error correction is used.